Harley Mount Storage Rack

Super sturdy. Worked great for my '08 EG accessories

Just hung the bracket. I am pretty impressed with the quality at this price point. I do agree that the screws could have been longer.However I had very little issue getting them on with the washer and lock washer. I also give a plus for the extra washers/screws. Non issue, but it also does not show the badging that it shows in the picture.

Started out skeptical of quality knowing it would be holding up my $3500 plus full harley touring king tour pack. Overall I’m thoroughly impressed and highly recommend for the price! Don’t recommend trying this but after installed I hung 200lbs from it just to see if it had a week link. After that i felt safe putting my tour pack on.Now for the bad…. You will have to drill 8 of the holes out just a hair bigger for the small screws to go through the holes of rods. You also will not be able to easily use the flat washers for the small screws (but really didn’t need them). The instructions paper is fairly clear about what holes to install the rods in. My suggestion is to mount all the rods to one side of the plate first, then fit the other side plate into its location and then tighten them up.I found the lag nuts to be more than adequate for holding the mount to the wall. I pre drilled a small pilot hole for each lag bolt so wouldn’t split the studs.For the price I’m very satisfied.

Works awesome easy to install overall very happy

Any structures engineer would have told you dangling 50lb tour pack off a cantilevered bolt to a wall is unsafe. Not a good design. Sadly didn’t get to attempt mounting until after Amazon return window closed so I’m stuck swallowing the disappointment otherwise would’ve returned for refund. Now just sits in my pile of scrap metal

The media could not be loaded. Easy to assemble with absolutely no problems. Great buy, & well made!Would highly recommended this rake when you have your pack off. Very surprised how some have had problems, none here at all.

I couldn't assemble the wall mount at first. As always with the Chinese stuff, you have to rework or parts are missing. The holes in the rods are half a millimeter too narrow - I had to drill out all the rods first.The screws are so incredibly short that you can hardly get the acorn nut together with the washer and the spring washer on the screw. I had to bend almost all spring washers together with pliers to get the nut onto the thread. Is it really such a problem to make the screws 2mm longer?When assembling the first nut, I soon went crazy because I couldn't get it onto the thread. At some point I noticed that there was no thread at all in the acorn nut! Of course I can try it out for a long time then.... But basically that's not a bad thing - because in the end I was missing a screw to completely assemble the wall mount. I'm going to get another nut and bolt now and then mount the wall mount. I'm curious to see if the solution is ok then.Not important, but worth mentioning: The white logo, print shown on the product images isn't available.

keeps it out of the way and safe from scratches etc out in the Garage.