Projectpak Double Bulb Socket, 2-Light Twin Cluster Socket, Incandescent Lampholder, Medium Base E26 Phenolic Double Light Socket, with 1/8 IP Bracket, Wire Leads

Worked well for my purpose! Although I've had a bit of issue getting rv (9 volt) bulbs to work in it! You'll want a small style bulb so it screw on enough to meet post inside socket! I had a larger bulb and the bulb would not work because the part that screws into the socket was not long enough and the bulb hit the socket and would not allow me to screw it in fast enough! Just something to keep in mind regardless of regular bulb or 9 volt bulb use!

Fast receipt & exactly as stated.

Replaced a broken socket, it works fine now

House had an old single bulb socket in a kitchen fixture and Installed this in order to get by with 2x 60w bulbs instead of 1x 100w bulb. The idea being to decrease shadows but also to lower the profile of the fixture by pointing the bulbs sideways rather than down. It worked just fine, and I accomplished my goals. Some people complain the it doesn't come with a locknut. This is true, so if you are replacing another socket save the old locknut or go to any hardware store and get a 1/8" locknut in the lamp section ahead of time.

I had to install some lights outside of my apartment building and these were the perfect fit and easy to install.

Very good quality and price I always buy to fix lights at the place I work

This is exactly what I needed to repair a lamp-holder in an aquarium lid. HOWEVER, it did NOT come with a NUT to hold it in place! Took me 45 minutes going through my supply of left-over junk parts to find one that worked OK. Quality-Control obviously sucks! Thus only 3 stars.

great item, great service

My dad used this to retrofit one of his floor lamps previously using a hard to find fluorescent bulb (ring shaped). It worked perfectly - the lamp now has 2 A19 LED bulbs that produce a comparable amount of light!