Threaded shaft motor

These are durable. I took a chance and repowered two solar fans with these (one each fan). They went strong all summer. I have a 200 watt, 12 volt solar panel running two fans powered by these motors and a third fan with a brushless motor meant to run on solar panels. These little motors spin at much lower RPMs than rated and operate in temps up to 160 degrees in my solar wood drying kiln all summer. I suppose the fan application helps keep them cooler but the ambient temps are very high. They probably ran at higher wattage than rated every day all summer in that environment. Good little motors.

Motor worked great. Good quality. Very smooth and quiet when tested in both directions. Much quieter than I expected, almost silent. Tested at 19V with a Motor Controller 0.3A at 50% and 0.4A at 100% no load. The shaft thread and nut well machined. I am very happy with this purchase. Planning on buying another one.

The torque is on the low end if using a potentiometer on this motor with the speed is very low, but when set at high speed it really has a lot of torque. It seems like pretty good quality and the price is good.

Easy to setup. The motor runs extremely smoothly and the mounting bracket ensures it's held into place. I used it for a inboard jet motor on my canoe. Still running strong to this day. Great diy motor

Low torque. Not strong enough for label engraver.

Motor works great, good for its size!

The description showed some uses for the motor such as a mixer motor. Well I was going to use it as a custom mixer to mix stuff like seeds for drying. At low speed, just touching the motor shaft stops it dead. But at high speed the torque seems good.

Use this for rock tumbling so it runs non stop days on end. Ran for a month and very little warmth detected on motor. Will buy again. Love it comes with a motor bracket.