NEEWER Upgraded 2.4G Remote Control for Motorized Camera Slider, Support Video Mode, Time Lapse Photography for Carbon Fiber Dolly Rail Slider NEEWER VS-80WC/100WC, ER1-120/100/80 （RT-08）

No se empareja con el slider ER1-120. Y el manual no es para nada claro, demasiado escueto. No viene con el cargador solo el cable.

とても良い。 初期設定が中々むずかしい！日本語取説もう少し丁寧にお願いします！

À bit complex to use.. you need to get used to it. But once you understand the user interface, the. It is less hussle in the operation of your slider. Also note that every 5-8 minutes the controller shuts down to save on battery. Then it takes sometime to turn it on again and you might loose on the moment.

Ich habe die Fernbedienung für meinen 100mm Slider gekauft. Der Slider hat eigentlich Bluetooth-Verbindung und App Unterstützung. Es funktioniert eigentlich sehr gut ABER: -Das iPhone geht schnell in den Ruhemodus und man muss immer wieder das iPhone entsperren -Wenn das Smartphone klingelt, kann der Slider nicht mehr bedient werden Die Bedienung mit dem Smartphone ist viel einfacher, intuitiver als mit der Fernbedienung eigentlich, ich wollte mit der Fernbedienung einfach ein Backup haben. Ich habe bewusst mich gegen das Modell mit der Fernbedienung entschieden, die out of the box Fernbedienung hat ein viel kleineres Display. Touchscreen wäre super aber bei dem Preis sollte man es nicht erwarten.

I bought this remote to go with the ER1 slider motor incase there is a day that the app is no longer supported in the future. I had to seek Neewer support, send videos and though their support replied, it was slow and also somewhat inaccurate. I sense it is a simple language barrier. At the time of writing this the limited support documentation for this RT-08 and ER1 is incorrect in how to sync and over simplified (for older remote). There is no Neewer Videos on the website nor on Youtube for this device but I have requested it occure for future. Following is the order of success for pairing: 1. Disconnect battery from motor and leave it for 10sec to completely reset. 2. On the motor press and hold the power button while inserting the battery and continue to hold the button for 8 sec to enter into pairing mode (you must force pairing mode). The next step is critical to occur at the same time. 3. While inserting the battery and holding the power button on the motor, after about 2 seconds then activate the remote in pairing mode by holding the power and photo buttons that are next to each other (as instructions state and this can be done one handed). 4. As the motor activates into pairing mode the timing of the remote also activating into pairing mode is essential (You have about a 1sec window). Only then will it sync up. Note: The app and remote cannot work at the same time so be sure the app is disconnected before attempting this. Once you have this running the remote and fine and works as intended. I suspect a firmware update may help. Secondary Note: I am on Mac and though the Neewer Firmware App can be downloaded, installed and bypass Apple security the actual Firmware updates cannot be run as they are not (at this time) Mac friendly nor can the remote be connected to the Mac. Thus there is no way to get the firmware onto the Remote. It does appear that the Motor accepts firmware updates via the app but the remote cannot be paired to the App for updates.