ICM Controls ICM203 Delay on Break Timer, 18-240 Vac, 1.25" Height, 2" Width 2" Length

Made in the USA

Our ac system constantly trips the freeze stat due to poor design and install by previous owners. Short of replacing an expensive newer system or throwing more money at supposed fixes I tried this to give the system plenty of time to equalize before cycling the compressor again. The new freeze stat was supposed to give more than a few minutes to reset but in reality it is two to three minutes. The thermostat was also supposed to prevent short cycling but it does not. To any hvac pros who might read this we have had five highly recommended companies out to service and troubleshoot at the expense of 2000$ with only modest results.I recommend this device. For us it has worked as intended.

Using this relay to keep my air conditioner from short cycling due to power fluctuations during storms.

Item was considerably cheaper than what Granger charges for theirs. Would purchase again from vendor.Installed one years ago on old condenser , and we get alot of thunderstorms and power surges.

I installed today, and of course I wanted to test if it worked. I turned on the AC and let it run for 5 minutes, then I pulled the breakers to look like I lost power. Then I turned back on quickly. Looking at my Nest Thermostat on my phone and standing outside, the Nest turned Blue that it was cooling. But the compressor did not come on. After 6 minutes which is the setting I used, the compressor started up. So it works as designed and it will save my compressor from all the power outages I have been experiencing. Thank You ICM !

Essential add-on to an A/C Unit for those hot & humid summer nights when the A/C cycles far to often for the 'health' of the compressor. Consider pre-assembling a simple jumper (Pic#1) to make the connection between the contactor-relay and the delay timer much easier & safer. If you have never worked around capacitors before, seriously consider getting someone who is familiar with this equipment to install it. Your compressor will thank you for the new timer.

Bought as a replacement part for my furnace blower motor timer relay works great saved me $300

I set it for 3 minutes and timed it and it took six minutes. Then I set it for 2 minute delay and I timed it 4 minutes 30 seconds. So either the arrow is in the wrong place or it's just inaccurate. Made in the USA thinking I would get a quality product. I'd like to get it down to 3 minutes but I'm O.k. with where it's at now not going to mess with it any more. The selling company shipped it very fast.