TP-3: Premium Performance Thermal Pad

Great product, lowered temperatures on my 2080 ti by 20 degrees celsius (the old one was extremely crusty). I used it on a few other graphics cards and all the temps dropped by at least 3-5 degrees C.

Works great. I found it easy to apply, though care is needed. In the reviews, I read about some users having issues with the pads tearing or crumbling. They are very soft and must be used with that in mind. Use a sharp razor, x-acto knife, or good scissor to cut them to approximate size. Remove plastic film from one side with tweezers, apply to the component, then remove the remaining film (again, with tweezers). Don't squeeze or press hard on these pads, they will deform due to their designed softness. I had zero issues with application. I can only assume the poor reviews were due to improper handling and installation. You need to know what you're ordering and install the thermal pads correctly with this in mind. As far as stickiness, I again had no issues here. They aren't made of adhesive, they stick as they should with proper care and installation. Thermal performance and temps improved on my Strix 1080 TI after replacement. I am happy with these pads.

Excellent product

Very delicate. That clear film is hell to deal with at this depth vs 1.5mm.But unless there is better one at 0.5mm it works..

I repasted my gpu and replaced the thermal pads and thermal paste. Everytime I played my pc crashes if I set the setting too high. I always have high fan with temp around 84 degrees then pc crashes.After replacing the thermals and thermal paste, my max temp is 71 degrees. So far everything is good, I haven't experienced any crashes after the replacement.

I used this to redo the thermal pads on an RTX 3090. It worked perfectly. My fans have not revved up in a long time.One single 200x100x1mm sheet is more than enough. Just don't forget that one side has the blue protective covering and the other side has clear plastic protective covering and you need to remove both when putting it on the card.Also, don't forget that you also want to add a square of thermal padding on the backplate. This is the square that sits directly under the die, in the recessed square. If you don't do this, your cards' temperatures will skyrocket.Don't overthink it. Just take your time.

I used these to mount 2 Awxlumv Large LED Aluminum Heatsinks 200 x 220 x 18mm to my Ubiquity UDM SE and highly recommend all Arctic products (I also used a tube of their compound to freshen up the thermal coupling between a CPU and heatsink).

arctic never disappoints! works like a charm!