MAIWOM.2 NVMe to USB Adapter, USB C PCIe Dock, USB3.2 GEN2x1 10Gbps With UASP Trim, 4TB Capacity, Tool-Free Lay-Flat SSD Enclosure Reader

I've use this to clone a Crucial P3 1TB from an old Toshiba NVMe and I've recently used it with an WD SN530 1TB on a Surface pro 7+. This adapter is so inexpensive but it works for everything I've needed it for. It's not going to give maximum speed for what some of these chips can do but it gives you more than enough speed and I believe I was getting about 300 MB per second during my heaviest cloning. Which was fine for my application.There's only one small issue I have with it and it has to do with the plastic enclosure. The plastic enclosure has a slot that you have to get your NVE chip through in order to make a connection to the actual port inside. You can see the port through a little window. The problem is this slot is exactly sized to the drive's width so when I placed the heat sink on the drive in order to place it in my Surface pro 7+ the heat sink made the drive slightly too wide and I could no longer insert it in the adapter. I had to use a whole other adapter to test out the final heatsinked drive. That was a minor irritation but could be a big issue if you're using any kind of heat sink. I didn't feel like trying to break the enclosure open or try to file the slot larger.They made it for bare drives only, please consider that when purchasing. I've also use it on devices that are low power and for the most part I didn't have a big problem but I'm unsure with some modern NVMe power requirements if you could use this with a USB-C hub or not. Likely not. Considering how inexpensive it was it was exactly what I needed so I'm thrilled with the purchase and will keep this for future uses. If you're looking for a full-time enclosure get something with the heat sink made of metal. This is for temporary use only but it does the job well and I experienced no disconnects or other oddities with the adapter. I recommend it for cloning and quick data recovery.

Facile à utilisé

It does anything and everything you'd expect from a m.2 SSD reader. Even plugs into my iphone 15 pro. Easy to use, great value, SSD fits snug.

My laptop came with a horribly slow hard drive. I needed to clone it out and replace it with a new NVME. I got this enclosure which seemed pretty good for the intended purpose. I used it with a WD850 NVME and transferred out all my data, installed it in my laptop and left the hard drive for backups. The laptop now boots up in seconds and it feels like a new one. Make sure the NVME doesn't have a heatsink, or it won't fit in the enclosure. Granted, it will get pretty hot during the transfer but it's for a one-off or perhaps ocasional use, so it shouldn't be a problem in the long run. I'm sure I will be using this a few more times with clients' laptops.

I didn't read the part that says its not for use with SSD's with a heatsink because the heatsink does not allow it to fit through the slot. But, the device worked like a charm, after I broke open its case and disassembled it. Cloned my SSD with heatsink intact in about 20 minutes. I was also able to snap the devices cover back together after.