🚀 Elevate Your 3D Printing Experience!
BIGTREETECHSKR Mini E3 V3.0 + BTT Pi V1.2 + TFT35 SPI V2.1 + SFS V2.0 Kit for FDM 3D Printer Upgrade Klipper Firmware for Ender-3, Ender-3 V2, Voron 2.4, Most of i3/Core XY 3D Printer
Y**K
Works like a champ
Once you figure out how to get this sucker working properly man can it make your printer hum
J**N
Release the Kraken!
Why should you buy this board? Yeah, this board is awesome. It has everything you could possibly want and more. You can run 8 different high amp steppers with this. When comparing it to the other boards, it is also the budget option. This has built in drivers. The high speed drivers for other boards would cost you more than just the Kraken!The real reason you should buy this board though is the black duck! If you are at all familiar with Bigtreetech products then you are likely obsessed with ducks. This dosnt have the typical yellow duck, it has a special black duck!The Kraken did work perfect in my custom printer build. Think I might buy another when I start a CNC build. The drivers provide enough power to run 4 large nema 23 steppers too!
S**M
Can't Recommend for High Current
They claim that this will run 60V and high amperage. It will not.I purchased a couple of these earlier this year and finally got around to using them. I intended to use them for a 6 axis robot, with NEMA 34s, which require the higher amperage. I hooked everything up according to the guide. The lower amperage NEMA23s I used on the upper arm ran just fine. The NEMA 34s made a pop, and then the driver section of the board died. That's over 100 bucks down the drain.Note that these same motors work just fine with real stepper drivers. If you intend to use this board for higher amperage for 3D printers/ CNC/ robotics applications, look elsewhere. It sounds too good to be true because it is.
B**M
Great board, defective mosfets for fan control though.
The board is great. Fans are DOA or stuck on, or stuck off. Depends on how your mosfet failed. This is a chronic problem on these boards. I did custom firmware just to make sure it wasn't that; nope. There is no way to control the fan port, even when pulling pin PA6 and PA7 which are the two fan pins. I tried contacting big tree tech, no reply. Going to my credit card next.
M**K
It works
You have to make new connectors for normal wireing it should have had a adapter to normal wireing
K**S
Top
Alles top, druckt super und der Sovol SV01 ist jetzt leise!
TrustPilot
1 个月前
1 个月前