Threshold Ramps for Doorways Self-Adhesive Rubber Ramps for Door Threshold Rubber Door Threshold Ramp for Wheelchair Stroller Scooter Reducer Ramp (Black, 3” Wide x 3.3' Long)

Perfect slant that fit right in front of our front door! Husband says it is so much easier to get over the threshold. Put a piece at garage door entrance to house too. Worked out great! Easy to apply, a little tough to cut but I did it!!

I had a new sliding door installed and needed a gab filled and covered. this work perfect, looks very clean and professional. just make sure that the sticky side goes on a clean, dust free and flat surface. then it sticks just fine.

I like that I can cut this to size any entrance I need it for.

Product: 3" Wide x 6.6" Long. I purchased for a vacuum robot. I have two thresholds, each is about 1/2" high (1st photo), so I doubled up and layered the product (photo 2). It works great for the robot to get up the "ramp". My RoboRock S8 could get up before I added the ramp, but he had to work very hard and make several tries. With the new ramp, no issues! I am going to glue the top layer shown in photo 2 to the bottom layer, but not attach it to the floor. This ramp will only be used when the robot vacuums. I am going to buy this product again as I have a 2nd door to do and its threshold is exactly the same. While I did not use it the adhesive that would glue it to the floor is very sticky (great!). The rubber seems to be good and sturdy and high quality (great!). The reason for 4 stars is because several others have commented the product is not straight (it curves) when you unfurl it from the box; it comes coiled up inside a 10" x 10" square box. In photo 3 I have temporarily laid and aligned the product to the wall on the left hand side (blue line) and you can see the gap on the right hand side (red arrows). I don't think this curl will be a problem if you use the adhesive, but as I said above, in my case I am not attaching the product to the floor and will only be placed over the existing threshold when the robot vacuum is working. I believe this lack of straightness is due to the coiling of the product inside the box due to the "slant" to create the ramp. I also believe if this product was packaged differently this lack of straightness would be resolved. I will try to use a heat gun to warm the product before I glue my two layers together and see if that helps. Luckily, the doorway is only about 2 feet wide, so there is only a small gap at this point from the curl. The piece in photo 3 is 29" long, so it is wider than my doorway, but shows the lack of straightness. The box the product came in is 10" x 10" so the product is tightly wound to fit in the box.

I use it to get onto my balcony in my wheelchair, and it works like a charm!

This arrived rolled, and while usually no problem I did have a hard time keeping it straight. The adhesive is not a powerful hold so keeps on coming up and curving. Would not purchased again. Would like a heavier material.

Works great

Needed to fix thresholds inside my house so a wheelchair could go over them. This worked well. It was easy to cut to size. The adhesive adheres well. Only complaint is they pick up dirt easily from everything that goes over them, so need to be cleaned frequently.