Skelang Cherry 3/4" x 50' Roll Wood Veneer Edge Banding Preglued Iron-On with Hot Melt Adhesive Edgebanding Flexible Wood Tape

👍

Edge banding worked an looks great plenty of glue for adhesion the few finger joints that are unavoidable where well made and hardly noticeable the only complaint is the banding is exactly 3/4 of an inch my plywood was 1/64 thinner but it worked if the banding was say13/16 I would give it 5 stars

I was thrilled at how easy it was to cut this thin, pliable veneer into strips (I then cut each strip lengthwise into thirds), drop on a little watered-down brown watercolor paint, and glue down into my dollhouse's rooms! (The herringbone pattern still shows a little glue still on top). I expect you could stain or shellac, too, because this is real wood. You can get exactly the look you want, in generous amounts, without the scary prices of buying ready-made hardwood floors for dollhouses, nor the cheap look of mere color photos of flooring. Great product for crafting!

I’m no where a wood expert, just a normal student want to do some DIY shelves. There is a few scraps of ply wood from my beginner wood working class that I took, sanded and mounted to the walls as decor shelves, nothing fancy. It was 3 months ago until I realize I could do veneer to make it look finished.This veneers are so easy to use with iron, I was hesitated to do for a while because the shelves were on wall already. But it was so easy to do, the adhesive start sticking after 5 seconds, I can move the veneer to align and press the iron 10-15seconds more to stick. So happy with the result.

This looks like domeone used some n returned it before I got it...I'm afraid I won't have enough of it now for my project ...

The product did exactly what it was supposed to do. Also, took stain and poly like a champ. Would buy again.

Very nice wood veneer tape. I didn’t use it because it was not close enough to the color I needed but the quality is definitely good.

I have not done any woodworking since high school shop class but getting this veneer affixed was super satisfying. The veneer is unfinished but has a nice matte look. It is perfect for a section under my kitchen countertop that had sustained water damage over the years. I had to remove the old veneer and attendant glue and then carefully measured out the right length. This veneer is easy to cut with a pair of sharp scissors. I taped it in place with blue painters tape, set the iron to the linen setting, and ironed it on slowly, following the iron with a wooden block to smooth out the glue and set the piece. I'm so happy with the results. Great product!