Eccotempi12-LP Water Heater, 4 GPM, Black

This is my third ecotemp i12. One in my home and one in my bus The first one failed after 7 years but it seems to have been acidic water so I can't blame the heater for that. Bought another brand that lasted 1 day so I went back to a brand and model that have given me good service.

Call me crazy, but I installed this in a 4000 square ft home with 4 bathrooms. It is just 3 of us though. So I think I can answer some questions people have in a larger home. I gave this thing 4 stars originally because of the lower power, but then UPDATED moved to 5 stars since it does so well for us. It looks awesome, sounds good, small, light weight. Most people in reviews talk about showers. Well our household take primarily baths. For filling a bathtub, you need to play with the settings. At 48 degree F water here in MI, I found turning water heater down to 1.5 gpm works. I set the temperature at 131 degrees at the water heater. By the time it gets to my huge Jaccuzzi, it goes down to 115 degrees. That is hot, so I was able to add a tiny bit of cold and got a Jaccuzzi tub full at 97 degrees in about 30 minutes. Not too bad. Plus it is hotter and can fill to any higher level than my previous 50 gallon water heater.Next test, a regular small bathtub, but at the far end of my house. The water lines run through the garage ceiling. By the time it gets there, it is at 106 degrees and takes about 10 minutes to fill the tub. This small tub actually was the hardest to get just right. Originally I had the water at 2.4 gpm, and it was fine for the big tub, but terrible for this far smaller tub. This is why I set the flow to 1.5 gpm right at the water heater. I think I will just leave it there, rather then keep having to adjust. Ok, 1.5 gpm is really low and 2 people cannot fill a tub at the same time, but it works for us and you can fill the 2nd tub immediately after. For your closer bathrooms, you can get a bit more gpm by adding some cold water. We had a 50 gallon direct vent gas water heater. This was not perfect either. We could never get more than 1/2 a tub before cold water started coming out. So even though this tankless water heater takes a longer time to fill a tub, it can keep going until it is full. So we just set the timer on the Jaccuzzi to 20 minutes and then come back and check on it. Compromises but the benefits are how efficient it is, how it never runs out of hot water, and since it is lower power, it has to be safer. It is safer than having a tank, that is for sure. Check water heater mythbusters on yout.So I am not necessarily recommending someone with a 4000 square ft house to buy this. Although for a conservative family that has no problem with compromising a little time for filling a tub for efficiency, you can definitely get by.Next test, faucets. You can run 2 faucets at the same time at my settings. I imagine at 2.5 gpm maybe 3 faucets but I do not want to keep changing the flow rate.I really love the touch screen and the looks are nice. Btw plan on a dozen trips to buy pipe parts. I also bought more exhaust vent. The exact same. Basically China makes these vent kits the exact same size so I can extend mine. Under 20 bucks online.Also plan on spending another 300 bucks on pipe parts. This is because you have to get the pipes from where your tank water heater was to where your tankless water heater is. I think it is worth it. It will save $250 a year. Btw, it felt good getting rid of that big bulky and ugly tank water heater.7/6/2017 Update: I just want to add that as the summer comes, I was able to lower temperature on the water heater to 113 degrees. So in the summer this thing has extra capacity available. I still just leave it at 1.5 gpm. Use of this water heater has become normal for us.

Water inlet came bent, thought it could possibly run my house that is about 1500 square feet and has one and a half bath but after seeing all the parts and pain for all the parts and spending over $500 on everything I did not want to install it as I was worried my water would not be clean enough and I would be replacing it very quickly unless you clean out the system and know how to plumb it in so if anybody wants one I believe the water inlet is not ruined but just bent and I have the exhaust pipe thimble , and water clean outs suggested and everything they recommended and didn't use it once and now can't return it! Ended up buying a used water heater that replaced the same size water heater I had and that had a stinky anal rod h10 cause us to sell the house because I remodeled it twice because of a roof leak on the second round and wanted a updated more efficient water heater but that tankless is for camping or cabin and you also want to have a lot of sediment filters prior to the water entering the tank otherwise it will get ruined so I also have a sediment magnet type sand filter I don't know what it is but it was around $100 so all in all I spent over $500 when I could have just got in a new water heater. So I would either get a nice $1,000 plus unit that can handle a little bit of minerals in the water or get a power vent water heater with a recirc pump because I also paid an electrician to install a electrical outlet so I'm probably into it about $600 but I'd sell this one 300 brand new and less ecotemp will take it back then I would give them shout outs because I know they make good products but this was their first digital touchpad that I seen and it said it can handle two bathrooms and the kitchen faucet but really it said like four gallons a minute maybe a little more but every plumber said it wasn't going to work for very long at least so ecotemp if you can take it back I have the box still and I would be glad to purchase another product that would go in my next home if you had a big enough unit otherwise I would purchase a less sophisticated unit and use it for camping.

Works better than I expected. After 3 weeks of use very happy with this product. I had very little space to work with, so its compact design was very helpful. Give yourself a couple days for installation as you need to make a wall hole for the burner exhaust, plumb in the cold and hot water connections, LP gas connections, and 115v power supply. It responds better to low and high flow demand than my old tankless water heater.