🔧 Elevate Your Engineering Game!
The Jeremywell UCF205-16 Pillow Block Bearing is a robust and reliable solution for your mechanical needs, featuring a 1-inch bore, 4-bolt flange mounting, and a self-aligning design. With its advanced heat-treated alloy steel construction and ISO 9001:2008 certification, this bearing is engineered for durability and performance, making it an essential addition to any professional toolkit.
T**T
Jeb crane bearing supports
I use these pillow bearings on my 2 ton jib Crane to handle a 10 foot I-beam supporting up to 4000 pounds of weight. No problem worked perfectly definitely would buy again.There is 1 issue with the bearings they won’t accept a 1 inch diameter steel rod I had to turn them down on my lathe,to fit the 1 inch bearingsTrent
S**.
Great quality- better than the original part I’m replacing!
Exactly what I wanted- firs great!
C**R
Iron housings need not be 90º
I understand the video complaint about the iron housings, they do not have to match up. It would be great to have made them symmetrical however the adjustments center the shafts independently, so to trash these because of that reason is not necessary. I ordered four bolts but received two bolt components, had to send them back. Still though I examined their quality and found them to be nicely made.
S**T
Set screws strip
The media could not be loaded. Other than the set screws stripping out it works very well for my application
M**T
I have used a 100 of these in a low speed application with no problems. Not sure about high speed
Like the cost
J**.
Quality Bearings
Making a custom weather wane. Using two bearing for better support
E**D
Self aligning bearings, don’t panic.
I received these and read the reviews where one of the bearings was out of alignment. Well mine had both out of wack. Put a 1/2” bolt in them and tapped them lightly and the paint broke loose to set them center. They are designed to allow for some slop if your flange mounts are not exactly parallel. Don’t panic, just use a little elbow grease to break them free and they will align correctly.
R**.
Great self aligning bearings
For the folks who wrote reviews about the bearings being misaligned, simply clamp the two bearings back to back and squeeze them together.The self aligning bearings will line up so that each starts out being at 90 degrees to the mounting face. But, if the shaft is not at 90 degrees to the face in use, the bearings will self align and not fail due to a misalignment.Great product and a great price.Thanks much