Rough Country Power Running Boards for for Jeep Wrangler JL, 4-Door (2018-2024) - Dual Motor Electric Powerstep Board & Retractable Steps

Loving the look and how easy it is to get in and out.Took about 3 hours to install. More time was need to run and tie up wiring then anything else. The instructions are good but the videos are better. Watch the videos if your going to do it yourself.

Love it easy to install

Looks like a quality product. I was lucky enough to have a lift although not required it makes things easier. Took about 2.5 hrs.I was a little disappointed that the harness did not connect to the door latch in the doors like the factory ones do but as long as the magnets stay on I think it will last a long time.

The steps are great, the written instructions are NOT great to say the least.Find the installation video on YouTube, it is far more useful. Main point - finish the wiring BEFORE mounting the steps to the motors, it gives you a lot more room to work.If you want a super clean install, start by removing both front seats, and the carpet under them.This will give you access to routing the cables from the passenger side to the driver's side inside, under the seats, instead of going underneath on the crossmember, and under the carpet at your feet for the switch.On my 2024 JLU, I ignored the instructions and ran the cable into the cab through a hole under the passenger seat that was covered by a big cap that was glued in. I pulled it out and used a big grommet to seal the hole.I also ignored the instructions to run the door switch wires over the pinch welds to behind the trim. I cut the wires, drilled holes in the pinch welds, used grommets, and re-soldered the wires on the other side. Super clean and far less likely to get broken, definitely worth the few extra minutes.For the on/off switch, I mounted it directly in the plastic dash instead of using the the cheesy stick on bracket it came with, where you would see the wire. Use a drill to start a hole, then spend a few minutes with a file to make it square.For the wiring between motors, use a drill (1/4" or so) to make a hole next to the existing big holes in the body and run your wire ties through them for a clean and tight install.Neither the written nor video instructions mention the little shims in the kit, but they are for adjusting the motor mounting back some to get the steps closer to the body, I needed them on the back motors only but it helps the fit.

Good delivery and all the parts were delivered. Installation was okay. The steps look great on the jeep. These are little noisy when they go up and down but I was aware they would. I am very satisfied with the product.

I've had these side rails installed for about a few weeks now. I'm an electrical engineer by trade, so for me, this was only a 3 out of 10 on the difficulty scale and took me approximately three and a half hours to complete the install. The instructions are good except for the rear spacers that have to be installed when you put the rear motors onto each side. Watch the YouTube installion video before the install. Wiring harness is good can be tough to install underneath the jeep, they could have given you longer tie wraps that would go all the way around your frame under the jeep when securing the wiring harness. I bought the 14 inch tie wraps at a local hardware store before the install. The step lights are very bright and work very well, make sure you position them properly, I installed lights to the center of each door also, when plugging the harness in to the control box, make sure the light leads are in the correct position as mine were backwards and didn't work until I switched the light leads around. As far as operation, they work flawlessly, they are a little noisy, but you can also use that slight nois as an indicator to make sure that your steps have gone back into the up position so when you drive away you know you're good. All in all, they look great solid performance so far. I'll give it 4 stars for now, and will update in a few months if all goes well, this will be a 5 star review....Update: Five stars had them on for 7 months and only had to adjust door magnet. Worked perfectly through winter ice and snow. No issues what so ever great purchase recommend.

The media could not be loaded. These ate amazing and the led lights are so bright they light up such a big area at night when deployed. And the drop on them makes it so much easier to get in a lifted jeep and tuck away nicely and the switch keeps them up when doors are off.

These running boards are outstanding easy to install and just like the manufacture said no holes to drill and instructions are clearI give this a great rating very satisfied WONDER FULL EXCELLENT PRODUCTI love my Jeep and only the best for her.