MaxonarWall Mount, Holder with Integrated Cable Management Space Saving Stand, Compatible with Echo Pop and Google Nest Speaker, White

This was super easy to assemble. It also came with screws and wall plugs so I didn’t need to get anything additional to be able to mount it on the wall. It fits the Echo Pop perfectly and the wire can be wound up in the back of the mount, too.

Got it on a discount £12.99. £19.99 seems excessive.

The only drawback is that it can't change direction vertically and horizontally

Very easy to fit

Great and adhesive to plastered brick wall is sufficiently strong so no drills reqd. Good cable tidy also

This is a pretty basic Echo Pop wall mount, no fancy swivels or extra gizmo's it just hold it where you put it, which to be fair is usually quite enough.Inside the box along with the main body of the mount you'll find a backplate with a clever little spirit level in it to help keep everything nice and straight, a small Philips head screwdriver, a nice strong piece of double sided tape and four rather larger screws than you'd expect along with wall plugs for them.Mounting is simple, decide where you want to put it place the back plate on the wall and mark the top hole, once you've drilled it and put the plug in put the plate back up put the screw in a few turns and keeping an eye on the spirit level mark the second hole, take it all down drill the second hole put the plug in and screw it all into place.Alternatively you can just use the double sided tape to put it up, again keeping an eye on the level while you put the plate in your chosen spot.Then it's a simple matter of running the power cable for your Pop through the holes provided and putting the mount on the plate fitting your Pop into the mount and powering it up.Out of the factory the mount is facing straight ahead.However there's a little feature that for some reason the advert fails to mention.If the position doesn't suit you it can be turned left and right (not up & down sadly) if you look at the back of the space where your Pop goes you'll see a small screw, simply take the provided screwdriver and take the screw out then pulling directly forwards (holding the mount base so you don't accidentally tear it off the wall) pull the front half of the mount away form the base, you'll see five pairs of slots for the tabs that hold the front in place, chose which direction suits you press the front into place and put the screw back.All done.The mount is a well made ABS plastic moulding that's lightweight but sturdy and should last for years.An unfussy simple design that does its job very well.There's nothing about it not to like.Five stars.

No problem installing this to hold my Eco pop.